How to Set a Watch to the Exact Time (Official Sources)

To set a watch to the exact time, compare it with an official time source: time.gov in the US, a national talking clock by phone, or a phone or computer that syncs automatically. Pull the crown out to stop the second hand at 12 (or hold the seconds at zero on a digital watch), wait for the source to reach the next full minute, and release on the beep or tick. Done carefully, this gets a watch within a fraction of a second; the delay of the phone line or network is usually smaller than your own timing error. This guide lists the official sources (with phone numbers), how accurate each is, how to set analog, digital and smartwatches, and how long the setting will last. Facts are as of November 2026.

Key facts (as of November 2026)

  • NIST talking time: WWV (303) 499-7111 and WWVH (808) 335-4363; landline delay “normally delayed by less than 30 ms”, mobile or VoIP “as large as 150 ms”; calls end after 2 minutes (NIST).
  • Canada: NRC talking clock 613-745-1576 (English), 613-745-9426 (French), announcing Eastern Time; satellite routing can add “0.25 seconds per hop” (NRC).
  • UK: dial 123 for the BT speaking clock; “The time is announced every ten seconds” (BT).
  • time.gov gives “an accuracy statement based on a measurement of the round-trip network delay” (NIST).
  • A quartz watch at the edge of a ±15 s/month spec is 1 s off after 2 days and 1 minute off after about 120 days (our calculation).

Official time sources you can use

  • time.gov (US). NIST’s web clock. NIST notes it shows “an accuracy statement based on a measurement of the round-trip network delay”, and that it is for time of day only: “it should not be used to measure frequency or time interval” (NIST FAQ).
  • NIST by phone. Call (303) 499-7111 for WWV (Colorado) or (808) 335-4363 for WWVH (Hawaii) and hear the radio broadcast with its ticks and voice announcements (NIST telephone time-of-day service). NIST says “The announced time is “Coordinated Universal Time” (UTC)” (NIST WWV/WWVH), so convert to your zone; our UTC to EST/PST chart helps.
  • NRC talking clock (Canada). 613-745-1576 in English or 613-745-9426 in French, announcing Eastern Time; the page says the beginning of the tone “indicates the exact time” (NRC).
  • BT speaking clock (UK). Dial 123; “Calls to this number are free, plus your network’s access charge” (BT).
  • A synced phone or computer. Most devices set themselves from the network or internet time servers; see how does my phone know the time? and what is NTP? A phone’s seconds display is usually good enough for a wristwatch.
  • Our clock. The ClockNow home page and city pages such as New York or London show seconds.

How accurate is each source?

For a wristwatch, the limit is usually you, not the source. NIST’s guide to calibrating stopwatches by hand says a person starting or stopping a watch against a signal makes errors that are “typically tens or even hundreds of milliseconds”; in a study it cites, “the worst case mean reaction time was 120 ms” (NIST SP 960-12, Stopwatch and Timer Calibrations, 2009). The delays the agencies state for their phone services are of a similar size or smaller:

Source Number Delay stated by the agency
NIST WWV by phone, US landline (303) 499-7111 less than 30 ms
NIST by mobile or VoIP (303) 499-7111 as large as 150 ms
NRC Canada talking clock, one satellite hop 613-745-1576 0.25 s per hop
NRC, two satellite hops 613-745-1576 0.5 s (two hops × 0.25 s, our calculation)

So a landline call to NIST, or a well-synced phone, is effectively exact for setting a watch. The NRC note about satellite hops matters mostly for long-distance calls; the delay is fixed, so if you need better, a local landline or an internet source is the better choice.

Step by step: analog watch

  1. Set the date first, if the watch has one, away from the window around midnight when many date mechanisms are engaged (check your manual).
  2. Pull the crown to the time-setting position. On many watches this stops the second hand (“hacking”); if yours does, pull it when the second hand reaches 12.
  3. Bring the minute hand exactly onto the target minute marker. If your manual says to approach the time from a particular direction, follow it.
  4. Listen or watch the source and push the crown in exactly at the full minute (the long tone or the “00” seconds).
  5. Check after a minute that the minute hand lines up with the marker as the second hand passes 12.

If the watch does not stop its second hand, set the minute hand to line up when the second hand passes 12, accepting a second or two of error.

Step by step: digital and smartwatches

  • Digital (button-set): enter time-setting mode, set hours and minutes one minute ahead, and press the button that zeroes the seconds at the exact top of the minute. Choose 12- or 24-hour display in the same menu; our 24-hour time chart shows the conversion.
  • Radio-controlled watches correct themselves from a time signal overnight; if one keeps the wrong time, check its home-city or zone setting first, then its reception.
  • Bluetooth-connected watches (including many Casio models) take the time from your phone. Casio’s spec of “±15 seconds per month average” applies only “when time adjustment by time calibration signal reception or by communication with a phone is not possible” (Casio module 5542).
  • Smartwatches follow the paired phone, so set the phone’s time zone correctly; our phone time-zone guide shows how.

How long will the setting last?

That depends on the watch. These figures use each specification at its limit, so most watches will do better; the specs are the manufacturers’ and COSC’s published limits.

Watch Drift per day (at the limit) Time until 1 s off Time until 1 minute off
Typical quartz, ±15 s/month 0.5 s 2 days 120 days
Grand Seiko 9F, ±10 s/year 0.0274 s 36.5 days 2190 days
COSC chronometer at its average-rate limit, +6 s/day 6 s 4 hours 10 days

A mechanical watch is worth checking every few days; a quartz watch every few months. A good habit is to reset at each clock change. Before 2028 those are:

Where Clock changes before 2028 (reset your watch)
US (most states), Canada east of Manitoba Mar 14, 2027, Nov 7, 2027
UK, Ireland, Portugal Mar 28, 2027, Oct 31, 2027
EU and most of Europe Mar 28, 2027, Oct 31, 2027
Sydney, Melbourne Apr 4, 2027, Oct 3, 2027
Auckland Apr 4, 2027, Sep 26, 2027

British Columbia, Alberta, the Northwest Territories, Manitoba, Saskatchewan, Arizona and Hawaii do not change clocks, so there is no seasonal reminder there; pick a fixed date instead. See clock changes 2026–2027 for every country.

Common mistakes

  • Using the wrong zone. NIST’s voice gives UTC; NRC’s gives Eastern Time. Convert before setting.
  • Setting AM/PM wrong on a watch with a date: the date will change at noon. Advance the hands through midnight to check.
  • Trusting a slow website. A web clock that does not measure network delay can be off by more than a second; time.gov states its own uncertainty.

How we checked

Phone numbers, delays and quotations were read on nist.gov, tf.nist.gov, nrc.canada.ca, bt.com and support.casio.com on November 9, 2026; we did not call the numbers. Drift times are simple division of each rate (computed in a script). Clock-change dates are from Python zoneinfo on IANA tzdata 2026f, re-read with glibc localtime(). The setting steps are general watch practice; follow your watch’s manual where it differs.

Sources

Frequently asked questions

How do I set my watch to the exact time?

Stop the second hand at 12 (pull the crown), set the minute hand one minute ahead, and push the crown in when an official source such as time.gov or a talking clock reaches that minute.

What number do I call for the exact time?

In the US, NIST at (303) 499-7111 (it announces UTC). In Canada, NRC at 613-745-1576 (Eastern Time). In the UK, dial 123.

Is my phone’s time accurate enough to set a watch?

Yes, for a wristwatch. Phones sync from the network or internet time servers, normally well within a second.

How often should I reset a quartz watch?

Every few months, or at each daylight saving change. At ±15 seconds a month it can drift a minute in about four months.

Why won’t my second hand stop when I pull the crown?

Not all movements have a “hack” (stop-seconds) feature. Line up the minute hand as the second hand passes 12 instead.

Similar Posts